INSL-X Semi-Gloss Swimming Pool Epoxy Coating Paint
INSL-X Semi-Gloss Swimming Pool Epoxy Coating Paint - Image 1
INSL-X Semi-Gloss Swimming Pool Epoxy Coating Paint - Image 2
INSL-X Semi-Gloss Swimming Pool Epoxy Coating Paint - Image 3

Categories

PaintDIYHardwareCleaning SuppliesHome Decor

INSL-X Semi-Gloss Swimming Pool Epoxy Coating Paint

$239.99

Sold by: Fargo Paints

Product Details

Rubber Based Swimming Pool Paint provides a durable low-sheen finish for use in residential and commercial concrete pools. It delivers excellent chemical and abrasion resistance and is suitable for use in fresh or salt water. Also acceptable for use in chlorinated pools. Use Rubber Based Swimming Pool Paint over previous chlorinated rubber paint or synthetic rubber-based pool paint or over bare concrete, marcite, gunite, or other masonry surfaces in good condition.

  • OTC-compliant, solvent-based pool paint
  • For residential or commercial pools
  • Excellent chemical and abrasion resistance
  • For use over existing chlorinated rubber or synthetic rubber-based pool paints
  • Ideal for bare concrete, marcite, gunite, and other masonry
  • For use in fresh, salt water, or chlorinated pools
  • View the sell sheet for more information

Specifications

Available Colours White, Ocean Blue, Royal Blue, Black Recommended For Use On Concrete, Marcite, Gunite, Fibreglass, and steel pool surfaces. Suitable for fresh and salt water pools. Key Feature(s) Two-component polyamide epoxy, extremely durable, chemical and chlorine resistant, long-lasting semi-gloss finish. Interior/Exterior Interior / Exterior (Pools & Fountains) Substrate Concrete, Marcite, Gunite, Fibreglass, Steel VOC Range 327 g/L (catalyzed) Coverage (Sq. Ft./Gal) 350–400 Number of Recommended Coats 2 Dry Time 2 hours (to touch) Recoat Time 3–72 hours Full Cure (Days) 7 days outdoor / 14 days indoor Vehicle Type Polyamide Epoxy Clean Up V704 Epoxy Thinner or Xylene, then warm soapy water Volume Solids (±1%) 62 ± 1% WFT: Wet Film Thickness (mils) 4.0–4.6 DFT: Dry Film Thickness (mils) 2.5–2.9 WPG (Weight per Gallon) 11.5 lbs Application Temp Range (°F) 50–100 Application Method Brush, Roller, Spray Sheen / Gloss Semi-Gloss (40–50 @ 60°) Flash Point 80 °F (27 °C) Mix Ratio (by volume) 1:1 (Base : Converter) Induction Time 30 minutes @ 77 °F (25 °C) Pot Life 6 hours @ 77 °F (25 °C)


SDS

SAFETY DATA SHEETS 
See More Details at Fargo Paints

More from Fargo Paints